Most recent
ASTM D178-22
Standard Specification for Rubber Insulating Matting
1.1This specification covers acceptance testing of rubber insulating matting for use as a floor covering for protection of workers.
1.2Two types of matting, differing in chemical and physical characteristics, are provided and are designated as Type I and Type II matting.
1.3The following safety hazards caveat applies only to the test method portion, Sections 17 to 19, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Note 1:Rubber insulating matting should remain flexible for use through normal temperature ranges.
Note 2:Rubber as used in this specification is a generic term that includes elastomers and elastomer compounds, regardless of origin.
1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM International [astm]