Historical
ASTM D2918-99
Standard Test Method for Durability Assessment of Adhesive Joints Stressed in Peel
This practice provides data for assessing the durabilities of adhesive joints by means of T-peel type specimens stressed in contact with air, air in equilibrium with certain solutions, water, aqueous solutions, or other environments at various temperatures. 1.2 This practice may be used as an accelerated screening test for assessing the durability of adhesive joints. It may be used to measure the durabilities of adhesive joints exposed outdoors or to environmental conditions experienced by adhesive joints in service. The tests may also be used to determine the effects of various surface preparations or substrates on durabilities of adhesive joints. 1.3 The durability performances of various adhesives may be compared by using this practice at uniform sets of conditions. To assess the over-all durability of a given adhesive, peel joints should be tested under a range of stress, relative humidity, and temperature. For a specific end use it may be possible to obtain the needed durability data using only one set of test conditions. 1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM International [astm]